CCR2P2A
CCR WITH CAN-BUS ANGLE & LENGTH SENSOR
Product description
This sensor is generally used to sense boom lengths and angle basic information for any load limiter or tipping control system on telescopic cranes, The cable in the drum can be steel made for just measurement applications with length from 3,5 m to 4,5 m , or electrical cable for signals transfer with length 3,5 m
CCR is equipped with redundant accelerometer sensor, to measure boom angle,
CCR installs internally an redundant accelerometer sensor, used to measure boom length, another basic information for load moment calculation.
This device available with CAN-BUS link only which grants better sensitivity and accuracy, reducing wiring through direct connection into a global CAN network.
CCR is equipped with redundant accelerometer sensor, to measure boom angle,
CCR installs internally an redundant accelerometer sensor, used to measure boom length, another basic information for load moment calculation.
This device available with CAN-BUS link only which grants better sensitivity and accuracy, reducing wiring through direct connection into a global CAN network.
Data sheet
CONNECTIVITY
1 CAN-BUS, CAN 2.0B (11 or 29-bit), ISO 11898-2 compliance, speed up to 1 Mbit/s, CAN-OPEN compatible.
ELECTRICAL CHARACTERISTICS
Power Supply
9 30 Vdc (Operates on vehicle power supply directly)
Supply Current 36mA@24V ; 50mA@12V
Connections
4 Poles connector: A=+VB; B=Gnd, C=CANL , D=CANH
Baud Rate
Programmable (50, 100, 125, 250, 500 Kbit/sec.)
Identifier Range
Programmable 11-29 bit
Transmission Rate
Programmable in 10 ms steps
Measuring Range
0 360
Zero Angle Reference
Freely programmable
Accuracy and Linearity
0,15 deg ( 0,3 deg in operating temperature range)
MECHANICAL CHARACTERISTICS AND RATINGS
Operating Temperature Range
from -20°C to +70°C
Storage Temperature Range
from -35°C to +85°C
Enclosure and Connector Protection
IP65