MC M
MACHINE CONTROL DUAL MANAGER INPUT/OUTPUT MODULE WITH MULTIPLE CAN BUS INTERFACE AND PWM OUTPUTS
MC M
MACHINE CONTROL DUAL MANAGER INPUT/OUTPUT MODULE WITH MULTIPLE CAN BUS INTERFACE AND PWM OUTPUTS
Product description
Controller with double processor expressly designed for centralized control of new generation mobile machines.
MC M is a main CAN BUS controller provided of high number of inputs (analogue, digital, RPM) and outputs (ON/OFF and PWM) software configurable.
It is based on FREESCALE microprocessors, freely programmable in "C" language.
Suitable for "safety critical" applications and to EN-280 for aerial platforms. All I/O connections are through a single automotive TYCO 120 pin connector, separate from a DEUTSCH 4 pin dedicated to power supply.
MC M is produced according to the ISO9001 quality standards.
MC M is a main CAN BUS controller provided of high number of inputs (analogue, digital, RPM) and outputs (ON/OFF and PWM) software configurable.
It is based on FREESCALE microprocessors, freely programmable in "C" language.
Suitable for "safety critical" applications and to EN-280 for aerial platforms. All I/O connections are through a single automotive TYCO 120 pin connector, separate from a DEUTSCH 4 pin dedicated to power supply.
MC M is produced according to the ISO9001 quality standards.
Data sheet
CONTROL SYSTEM
2 Freescale Microprocessors
16bit, clock 40 MHz
Flash memory
512KB for control program (expandable up to 2 MB)
RAM
32 KB for control program (expandable a 256 KB)
EEPROM
8KB for parameters
RTC (real time clock)
with 256KB Flash for Black Box
INTERFACES
3 CAN-BUS interface, standard 2.0B (11 or 29 bit identifier), according to ISO-11898, baud rate up to 1Mbit/s
2 LIN BUS master
1 RS232
CONNECTORS
1 automotive connector TYCO 120 pin for I/O
1 connector DEUTSCH 4 pin for power supply
POWER SUPPLY
Main power supply
from +9 to +30 V DC full operational (suitable for battery direct connection)
Logic power supply (COLD CRANKING)
from +4 to +30 V DC
Separate power supply for each 8 outputs bank
Internal safety relais controlled by watchdog, used to disconnect outputs in case of hardware or software malfunctions.
CERTIFICATIONS
The controller is certified for following automotive standards required by 89/336 CE
1) EMC standards for emission, immunity for industry (high density industrial environment)
Reference standard
EN 61000-6-4
Base standard
EN 55011 (RF Emission)
2) Electromagnetic immunity, low density environment
Reference standard
EN 61000-6-2
Base standard
EN 61000-4-3 (Radio Frequency)
EN 61000-4-4 (Burst)
EN 61000-4-6 (Conducted disturbance)